Terminal Units / Gas Outlets (Probes)

Conforms to:  IS/ISO 9170-1:2017, IS/ISO 9170-2:2008
DIN 1360-2:2004, BS 5682:2015 & CGA V-5:2019

Certifications: CE Medical Devices Marking according to 93/42/EEC Directive
ISO 13485:2016 – Medical devices – Quality management systems
ISO 9001:2015 – Quality management systems

Special Features

  • Stable Connection.
  • Quick to connect and disconnect.
  • 3 delta finish for long “O” ring life of the outlet
  • Indexed to specific gas service
  • Laser engraved identification of gas service
  • Customizable patient end connection
  • Right angled (90 degree) patient end connection on request
  • MRI compatible
  • Made from AISI 304 Steel (Except Ohmeda compatible probe)

Probes are crucial for gas specific and stable connection. These are used to connect medical gases and vacuum devices to outlets / terminals of MGPS distribution network.

Manufactured in wide range of Quick connect and DISS types compatible to various Outlet / Terminal standards, maintaining gas specific keying safety.

Patient end connection to medical devices are available in 6 mm OD Hose barb, 1/8” BSPT, 3/8” BSP, options. However, customized patient end connection, angled connection and various end fitting are also available on request.

Probes are available for O, NO, O / NO (Entonox), CO, Vacuum, Meddical Air -Ar4, Instrument Air -Ar7, Nitrogen, 2 2 2 2 2 Helium/oxygen mixtures (Heliox), AGS, Triple mix gases (Tri-Gas: CO, O & N ) and Gases and gas mixtures classified as 2 2 2 medical device.

Anaesthetic Gas Scavenging Probes

Patient End Conversion Connectors

NOTE : Probes / Connectors of other standards I.e. AGA, JIS, AFNOR etc. are available on request.


DISCLAIMER: Aktiv Probes / Connectors / Adapters meet and exceed the requirements of relevant standard at the time of manufacture.

However piping source, capacity, sizing and restrictions may prevent from attaining the stipulated value.